Compilation

Follow the steps below to compile:
  1. Execute the following command to compile:
    make -j8
    Note: The compilation may take 2 hours.
  2. Execute the following command to generate an SD card image:
    bin/targets/jh71x0/generic/
openwrt-jh71x0-generic-visionfive2-v1.3b-ext4-sdcard.img.gz
  3. Unzip the SD card image:
    gunzip openwrt-jh71x0-generic-visionfive2-v1.3b-ext4-sdcard.img.gz
  4. Flash the image into the SD card:
    dd if=openwrt-jh71x0-generic-visionfive2-v1.3b-ext4-sdcard.img of=/dev/sdX bs=1M
oflag=direct
    Note:
    • For Windows, you can use balenaEtcher to flash the image.
    • Since the image does not include SPL and U-Boot, Nor Flash needs to have SPL and U-Boot flashed and should boot with QSPI Nor Flash.
    • Use the sudo fdisk –l command to find your device so that you can replace X value. For example, if your device is /dev/sdb, X should be b.
  5. Open OpenWrt。