RPi_demo Source Code

#import RPi.GPIO as GPIO            # import RPi.GPIO module  
#*******************************************************
#Note: above command must be replaced with command below
import VisionFive.gpio as GPIO      # import VisionFive.gpio module 
#*******************************************************
from time import sleep             # let us have a delay  


GPIO.setmode(GPIO.BCM)             # choose BCM or BOARD  
GPIO.setup(36, GPIO.OUT)           # set GPIO27 as an output   
  
try:   
    while True:   
        GPIO.output(36, 1)         # set GPIO27 to 1/GPIO.HIGH/True  
        sleep(0.5)                 # wait half a second  
        GPIO.output(36, 0)         # set GPIO27 to 0/GPIO.LOW/False  
        sleep(0.5)                 # wait half a second  
  
except KeyboardInterrupt:          # trap a CTRL + C keyboard interrupt
    GPIO.cleanup()                 # reset all GPIO ports used by this program

#import RPi.GPIO as GPIO
#*******************************************************
#Note: above command must be replaced with command below
import VisionFive.gpio as GPIO
#*******************************************************
from time import sleep

ledpin = 36                # PWM pin connected to LED
GPIO.setwarnings(False)        # disable warnings
GPIO.setmode(GPIO.BOARD)       # set pin numbering system
GPIO.setup(ledpin, GPIO.OUT)
pi_pwm = GPIO.PWM(ledpin, 1000)    # create PWM instance with frequency
pi_pwm.start(0)                   # start PWM of required duty cycle 
while True: 
    for duty in range(0, 101, 1):
        pi_pwm.ChangeDutyCycle(duty)  # provide duty cycle in the range 0-100
        sleep(0.01)
    sleep(0.5)
    
    for duty in range(100, -1, -1):
        pi_pwm.ChangeDutyCycle(duty)
        sleep(0.01)
    sleep(0.5)